Instruction manual

5・40
Chapter 5 Menu Operation (Display)
Assign Address
Displays Again
Display Type
Jump
Content
Assign the address to be displayed in the data list at the [Assign Address]
dialog box. [Assign Address] dialog box will be displayed when this
particular item is clicked.
Item
・If you click [▼] and select the kinds of register, and click [OK] after
inputting the address, the data list of the assign area will be displayed.
You can also assign the address by "double click the left side of the
mouse" or by inputting the [Enter] key.
After selecting the program address of the cross reference display, if you
click [View]-[Jump], the cursor will move to the instruction of the program
address. Note that, you can also do the same operation by
"double click the left side of the mouse." the program address of the cross
reference display.
Create again the data list for every program and display.
Assign the display type of the data list at the [Setup Display Type] dialog
box. [Setup Display Type] dialog box will be displayed when this particular
item is clicked.
◎ Symbol Display
Select "Do / Undo" of the display of the symbol which is setup at
relay /register. Select the item by clicking.
◎ Comment Display
Select "Do / Undo" of the display of the comment which is setup at
relay /register. Select the item by clicking.
◎ Reference Display
1 Row : After the assigned address, display the cross reference of the
continuous address by each row.
Detail : Only the cross reference of the assigned address will be
displayed repeatedly inside the cross reference display area.
Undo : Cross reference is not displayed.
●●
●●
● [View] menu