Instruction manual

5・36
Chapter 5 Menu Operation (Display)
■■
■■
■ Change Segment File (Program)
Change the display of the program memory (file8/9).
・When the memory volume of the program exceeds 31.5K words, change the display between 00000
and 76777 (file8) and 100000 and after (file9) of the program address.
・File 9 is used as the destination of the divided branch created by the jump instruction (F-141,F-151), or
used as the hangar of the sub routine program created by the sub routine call instruction (F-142,F-148).
・Each function such as program check, change from ladder to mnemonic, change from mnemonic to
ladder, transfer to the main PC, save in the file, or print will be executed in batch at the file 8/9.
File 8 File 9
ＥＮＤ
Address
000000
076776
076777
F-141
JMP
LB0000
F-140
LABL
LB0000
ＥＮＤ
Address
100000
176776
176777
JUMP
File 8 File 9
ＥＮＤ
Address
000000
076776
076777
F-142
CALL
LB0001
F-140
LABL
LB0001
ＥＮＤ
Address
100000
176776
176777
CALL
F-143
RET
(2) Operation content
① Click [Display]-[Changes Type of Monitor] of the menu bar of the program：ladder
⇒ [Setup Monitor Display Mode] dialog box will be displayed.
② Select type of monitor display mode. Select from
either "Simple Display" or "Detail Display."
③ Select type of register display mode
Select from "HEX" (hexadecimal notation),
"DCML" (decimal notation),"OCT" (octal notation).
④ Select effetive area of type of register display
When selecting "Detail Display," select either "All
Registers" or "The Infinitive Register of Number
Type."
⑤ Click [OK]
⇒ Selected content is registered.
②
③
④
⑤