Specifications

20
9300 Mobile Computer Reference Manual
1.3.1 KEYPAD SETTINGS
The LED backlight of keypad is turned off by default. Press to toggle it from off to
on, and vice versa. It is suggested to turn on the keypad backlight while working in a
dark area; however, using backlight while on battery power will substantially reduce
battery power.
The Character Repeat functionality is enabled by default. Go to Start | Settings |
Control Panel and double-tap the Keyboard icon. You may cancel the check box to
disable it. When enabled, tap, hold, and drag the slider for a desired Repeat Delay and
Repeat Rate.
1.3.2 ALPHA KEY
This alphanumeric keypad is set to numeric mode by default. The Alpha key serves as a
toggle among numeric, alpha (lower-case alphabetic), and ALPHA (upper-case
alphabetic) input modes.
Note: It is not necessary to hold down the [Alpha] key.
The alpha icon will appear on the status bar in a sequence as shown below.
Status Icon
Alpha Key Input Mode
--- Numbers
Press
one time Lower-case alphabetic
Press
two times Upper-case alphabetic
Note: If you are using the software keypad via SIP, tap CAP (Caps Lock) to toggle
between upper case and lower case alphabetic modes.
1.3.3 SPECIAL KEY
Status Icon Ctrl or Alt Key Input Mode
Press
one time
User-definable: The Ctrl key modifies the
next key pressed.
Press
one time
User-definable: The Alt key modifies the
next key pressed.