Specifications

124
9300 Mobile Computer Reference Manual
Timeout between
same symbols
When in Continuous mode, set the minimum time that
must elapse before the scan engine decodes a second
barcode, which is identical to the one that has just been
decoded. This reduces the risk of accidentally scanning the
same barcode twice.
 0.0~9.9 (second)
1.0 sec.
SYMBOLOGY SETTINGS TABLE
Laser Engine Description Default
Code 11 Enable
Verify Check digit Decide whether to verify the check digit. If the check digit
is incorrect, the barcode will not be accepted.
 No verification
 One Check Digit
 Two Check Digits
No
Transmit Check Digit Decide whether to include the check digit in the data being
transmitted.
 "Verify Check Digit" must be enabled.
No
Select Length
 One or two fixed lengths
 Range (1~55)
4~55
Codabar Enable
CLSI Editing When applied, the CLSI editing strips the start/stop
characters and inserts a space after the first, fifth, and
tenth characters of a 14-character Codabar barcode.
 The 14-character barcode length does not include
start/stop characters.
No
NOTIS Editing Decide whether to include the start/stop characters in the
data being transmitted.
 NOTIS Editing is to strip the start/stop characters, i.e.
to disable "Transmit Start/Stop Characters".
No
Select Length
 One or two fixed lengths
 Range (1~55)
4~55
Code 128 Enable
Code 128 Read standard Code 128 barcodes (= without leading
FNC1 character).
Enable
GS1-128
(UCC/EAN-128)
Read GS1-128 barcodes with leading FNC1 character. Enable
ISBT 128 Read ISBT 128 barcodes. Enable
Industrial 25 (Discrete 25) Enable
Select Length
 One or two fixed lengths
 Range (1~55)
4~55