Specifications

B-2
Changing the Suspend-to-disk Partition Size
The suspend-to-disk partition size should be 3 MB bigger than the installed
memory. The table below shows the minimum size of the suspend-to-disk
partition that is required for different memory installations. The suspend-to-disk
partition is expressed in kilobytes (1 megabyte equals 1024 kilobytes) since this is
the figure you need when you use the PHDISK utility to create the new partition.
Installed Memory Suspend-to-disk Partition
16 MB 19456 KB
24 MB 27648 KB
32 MB 35840 KB
48 MB * 52224 KB
•
Size of the factory default suspend-to-disk partition
To create a new suspend-to-disk partition, see the following steps in the Re-
installation Instructions.
•
Backing up the data
•
Changing values in the Setup Utility
•
Deleting the suspend-to-disk partition
•
Deleting the DOS partition or Logical DOS Drives
•
Creating the suspend-to-disk partition
Memory Management Software
If you install memory management software such as EMM386, QEMM, 386Max,
etc., you might find that it creates a conflict with the PC card drivers that your
notebook uses. This conflict can cause the notebook to hang up when you try to
close the Setup utility.
The solution to this problem is to modify the memory management software so
that it does not use the following system and BIOS memory locations:
D000-D7FF
Consult the documentation of your memory management software for the correct
method of excluding these memory locations.