Datasheet NUSC360

Cells Monocrystalline, 156.75 mm × 156.75 mm, 72 cells in series, cell encapsulation: Ethylene-Vinyl-Acetate
Front glass Anti-reflective low iron tempered glass, 4 mm
Frame 40 mm anodized aluminium alloy, silver
Connection box IP67, 3 bypass diodes
Cable 4.0 mm², length 1,200 mm
Connector MC4
Modules per pallet 27 pcs
Pallet size (L × W × H) 1,990 × 1,140 × 1,170 mm
Pallet weight 750 kg
Packaging dataGeneral data
Electrical data (NOCT)
Electrical data (STC)
Contact Sharp
SHARP ELECTRONICS GMBH
ENERGY SOLUTIONS
NAGELSWEG 33 – 35
20097 HAMBURG
GERMANY
T: +49(0)40/2376-2436
F: +49(0)40/2376-2193
Contact Installer
www.sharp.eu
Empower yourself
Note: Technical data is subject to change without prior notice. Before using Sharp products, please request the latest data sheets from Sharp. Sharp accepts no responsibility for damage to devices which have been equipped with Sharp products on the basis of unverified information. The specifications may deviate slightly and are not guaranteed. Installation and operating instructions are to be found in the corresponding handbooks, or can be downloaded from www.sharp.eu/solar. This module should not be directly connected to a load.
Length 1,956 mm
Width 992 mm
Depth 40 mm
Weight 26 kg
NOCT 44°C (+/-2 °C)
P
max
-0.39 %/°C
V
oc
-0.29 %/°C
I
sc
0.05 %/°C
Mechanical data
Temperature coefcient
Dimensions (mm)
*Please refer to Sharp’s installation manual for details.
Maximum system voltage 1,000 V
DC
Over-current protection 20 A
Temperature range -40 to +85° C
Max. mechanical load (snow / wind) 2,400 Pa
Tested snow load
(IEC61215 test passed*)
5,400 Pa
Limit values
NUSC36_08/17EN
Local responsibility: Benelux [e-mail], France [e-mail], Germany [e-mail], Poland [e-mail]
Spain & Portugal [e-mail], United Kingdom [e-mail], Other countries [e-mail]
NUSC360
Maximum power P
max
360 W
p
Open-circuit voltage V
oc
47.2 V
Short-circuit current I
sc
9.79 A
Voltage at point of maximum power V
mpp
38.9 V
Current at point of maximum power I
mpp
9.26 A
Module efficiency

m
18.5 %
STC = Standard Test Conditions: irradiance 1,000 W/m², AM 1.5, cell temperature 25 °C.
Rated electrical characteristics are within ±10 % of the indicated values of Isc, Voc and 0 to +5 % of P
max
(power measurement tolerance ±3 %).
NUSC360
Maximum power P
max
268 W
p
Open-circuit voltage V
oc
43.8 V
Short-circuit current I
sc
7.88 A
Voltage at point of maximum power V
mpp
35.9 V
Current at point of maximum power I
mpp
7.47 A
Module operating temperature at 800 W/m² irradiance, air temperature of 20 °C, wind speed of 1 m/s.
992
Drain Hole
Grounding Hole
11
35
1956
40
1200±10
180180