User Manual

Appendixes
A-15
Be sure to connect the AC adapter. If the battery is completely
discharged, the installation process will be canceled.
5. When the message Press F2 for System Utilities appears, press F2. The Setup
Utility opens.
6. Insert the Recovery CD disc 1 into the optical drive.
Always hold the CDs by the edges. Fingerprints, dirt or water on the
CDs cause improper tracking. If a CD is dirty or does not work properly,
clean it with a soft, dry cloth, wiping straight out from the center, along
the radius.
7. In the Exit menu, select Load Setup Defaults; then, press Enter twice.
8. In Boot Sequence of the Boot menu, set CD-ROM Drive to the top of the list;
then, press ESC.
9. In the Exit menu, confirm Exit Saving Changes is highlighted and press Enter
twice.
10. Select your optical drive from the options on the screen, then, press Enter.
11. Read the message on the screen, and select the way to recover your system; then,
press Enter. If you select Formats hard disk and creates new partition, go to the
next step. Otherwise, go to Step 13.
When you select Recovers both C: and D: drive or Formats hard disk and
creates new partition, the recovery process will delete the recovery data
installed in the hard disk.
12. Select the volume of C: drive and press Enter.
13. Read the message and select Continue; then, press Enter. Follow the on-screen
instructions for replacing the recovery CDs.
Although the pointer may be shown on the screen, never touch the
keyboard, the mouse or the screen during recovery except when the
message prompts you to. If you touch them, the re-installation will be
canceled.