User Manual

A-14
Appendixes
• Never use the hard-tip materials to write on the CD-R for labeling.
• Do not write on the non-label side. Data is read from the non-label
side. Do not mark this surface.
Wait about ten seconds for recognizing it after replacing a blank CD-
R/RW; then, click OK. Otherwise, an error will occur when starting
burning process.
7. When you see the message CD creation complete on the screen, click OK, then,
Close.
8. Click Yes and remove the CD-R/RW from the optical drive.
9. Restart your computer.
• Store the burned discs in a secure place.
• Keep your disks away from direct sunlight, heat and excessive
moisture.
10. Remove the external optical drive if you don’t use it.
When you disconnect the external optical drive, you need to stop the
device. Follow the instructions on USB Device section of Chapter 5.
Recovering with Recovery CD
• When you format entire of the hard disk drive (both C: and D: drives),
the recovery data installed in it will be eliminated. Therefore you will
not be able to recovery your system via hard disk.
• Be sure to use one of the recommended drive units (LITEON LSC-
24081M USB Drive (Combo) or SHARP CE-CD05).
1. Make sure your computer is turned off.
2. If any peripheral devices are connected to your computer, disconnect them.
3. Connect an external optical drive unit.
4. Connect the AC adapters to your computer and the external CD drive unit; then,
turn on your computer.