MX-M550U/N/M620U/N/M700U/N Operation-Manual Administrator-Settings-Guide GB
Table Of Contents
- Contents page
- PURPOSE OF THE ADMINISTRATOR SETTINGS
- ADMINISTRATOR SETTINGS LIST
- USING THE ADMINISTRATOR SETTINGS
- GENERAL SETTINGS
- Account control
- Job log control
- Energy save
- Operation settings
- Device control
- Original size detector setting
- Disabling of document feeder
- Disabling of duplex
- Disabling of large capacity cassette
- Disabling of stapler
- Disabling of punch
- Disabling of finisher
- Disabling of inserter
- Disabling of covers/inserts mode
- Saddle stitch position adjust
- [AUTOMATIC SADDLE STITCH] checkmark
- Saddle stitch stapling exceptions
- Auto switching of finisher trays
- Rotated output
- Auto paper selection setting
- Optimization of a hard disk
- Network settings
- Security settings
- List print
- Sharp OSA settings
- Change admin password
- Product key
- Initialize and/or store settings
- COPY SETTINGS
- Copy settings
- Initial status settings
- Exposure adjustment
- Rotation copy setting
- Add or change extra preset ratios
- Initial margin shift setting
- Erase width adjustment
- Card shot settings
- Initial tab copy setting
- Setting a maximum number of copies
- Disabling deletion of job programs
- Disabling of bypass-tray in duplex copy
- Disabling of auto paper selection
- Copy settings
- DOCUMENT FILING SETTINGS
- TO THE ADMINISTRATOR OF THE MACHINE
4
USING THE ADMINISTRATOR SETTINGS
The procedure for configuring the administrator settings is explained below using the "Change admin password" as
an example. Follow the same steps to configure the settings that are described beginning on page 7.
1
Press the [SYSTEM SETTINGS] key.
2
Touch the [ADMINISTRATOR SETTINGS]
key.
3
Use the numeric keys to enter the 5-digit
administrator password.
Each time a number is
entered, the dashes (-)
in the display will change
to asterisks ( ). The
factory default setting for
the key operator code
number is 00000.
4
Touch the [CHANGE ADMIN PASSWORD]
key .
If you wish to configure a
different administrator
setting, select the
desired setting in this
step.
A screen for the selected
setting will appear.
Configure the setting as explained on pages 7 and
following of this manual.
5
Use the numeric keys to enter the new
5-digit administrator password.
Use a number for the
administrator password
that has not been set as
an account number for
auditing mode (a
number that has been
set as an account
number cannot be used).The entered number will
be the new administrator password. Be sure to
remember this number.
6
Touch the [OK] key. You will return to the
screen of step 4.
This completes the
procedure for changing
the administrator
password. If you wish to
configure another
setting, touch the key of
the desired setting in the
screen of step 4.
7
Touch the [EXIT] key.
You will exit the
administrator settings.
PY
JOB STATUS
SYSTEM
SETTINGS
ADMINISTRATOR SETTINGS
SENDER CONTROL
FAX DATA
RECEIVE/FORWARD
ADMINISTRATOR PASSWORD
CHANGE ADMIN
PASSWORD
NGS
PRINTER
SETTINGS
00000
-----
OK
OPERATION
SETTINGS
EXIT
PRINTER
1/2