N Operation-Manual Administrator-Settings-Guide GB

Table Of Contents

GENERAL SETTINGS

Tandem setting

This setting is used to configure the IP address and

port number of the client printer when you wish to have

two machines (which are used as TCP/IP network

printers) print in tandem.

The factory default setting for the port number is

[50001]. Unless you experience difficulty with this

setting, it does not need to be changed.

The tandem function can also be prohibited, or the

reception of tandem data from the other machine can

be prohibited. (Normally this is not necessary.)

To prohibit the tandem function, select "DISABLING

OF MASTER MACHINE MODE".

To prohibit reception of tandem data from the other

machine, select "DISABLING OF SLAVE MACHINE

MODE".

PING command

This setting is used to check if the machine and a

computer connected to the network can communicate.

Enter the IP address of the computer that you wish to

check and touch the [START] key. A message will

appear indicating whether or not there was a response

from the computer.

Security settings

The following settings are related to security. Touch the

[SECURITY SETTINGS] key to configure the settings.

SSL setting

SSL can be used for data transmission over a network.

SSL is a protocol that enables the encryption of

information communicated over a network. Encrypting

data makes it possible to transmit and receive sensitive

information safely.

• HTTPS: Apply SSL encryption to HTTP

communication.

• IPP-SSL: Apply SSL encryption to IPP

communication.

List print

This setting is used to print lists and reports that can

only be printed from the administrator settings.

• Touch the [ADMINISTRATOR SETTINGS] key to

print one of the following groups:

Copy, printer, fax/image send, document filing,

general, security, all administrator settings lists

• Touch a key other than the [ADMINISTRATOR

SETTINGS] key to begin printing a list or report.

Sharp OSA settings

The following settings are related to OSA. Touch the

[Sharp OSA SETTINGS] key to configure the settings.

● Default display setting

● External account setting

Default display setting

The default screen that appears when the

[DOCUMENT FILING] key is pressed can be specified.

Select either the base screen of document filing mode

or the external application selection screen. This

setting can only be configured when the application

communication module is installed. The setting also

appears in the document filing settings.

When the [CA] key ([Clear all] key) is pressed in

document filing mode or Sharp OSA mode, the initial

screen of the mode appears, regardless of the default

display setting.

External account setting

When [ENABLE EXTERNAL ACCOUNT CONTROL]

is enabled, the machine enters external count mode.

When both [ENABLE EXTERNAL ACCOUNT

CONTROL] and [ENABLE AUTHENTICATION BY

EXTERNAL SERVER] are enabled, the machine

enters external authentication mode. This item can

only be selected when the external account module is

installed.

Change admin password

This setting is used to change the administrator

password that must be entered to configure the

administrator settings. When the machine is first used,

the administrator should change the administrator

password that was set at the factory to the desired

5-digit code. Only one administrator password can be

set.

The factory default setting for the administrator

password is 00000.

NOTE

To use the tandem function when auditing mode is

enabled, the same account number must be entered

on both machines. If the same account number is not

entered, only the server machine may print or the

printed pages may not be added to the correct

account.