MX-M350U/N/M450U/N Operation-Manual Copier GB

TROUBLESHOOTING
2-24
Printing stops
before the job is
finished.
If too many pages collect on the output
tray, the tray full sensor activates and
stops printing.
Remove the paper from the output tray.
The paper tray is out of paper. Load paper. (Page 2-2)
Smudges on printed
sheets.
Does a message appear indicating the
need for maintenance?
Please contact your dealer as soon as possible.
The displayed paper
size or paper type
does not match the
loaded paper size or
paper type.
The correct paper size or paper type is
not set in the paper tray settings of the
system settings.
When loading paper, if you change the paper
size from an inch size to an AB size, or from an
AB size to an inch size, or change the paper
type, be sure to set the new paper type as
explained in "Setting the paper type and paper
size" (see page 2-5).
When printing on a
special size of
paper, part of the
printed image is
missing.
The paper size setting is not set
correctly in the paper tray settings of the
system settings.
When using a special size of paper, set the
correct paper size as explained in "Setting the
paper type and paper size" on page
2-5 . If the
paper size setting is not correct, part of the image
may be cut off or the image may not be printed.
Paper misfeeds
frequently.
Is paper other than SHARP-
recommended paper being used?
Use SHARP-recommended paper. (Page 2-16
)
Paper curled or damp?
Do not use curled or crimped paper. If you will
not use the paper for a long time, remove the
paper from the tray and store it in the wrapper in
a cool and dark location so that it will not absorb
moisture.
Is the paper curled and does it
frequently misfeed in the finisher or
saddle stitch finisher?
Paper may be curled when output depending on
the paper type and quality.
In some cases turning the paper over in the tray
will reduce misfeeding due to curling.
Multiple sheets of paper fed
simultaneously?
Remove the paper
from the paper
tray or the bypass
tray, fan the paper
as shown in the
illustration, and
then load it again.
The paper in the tray is not stacked
evenly.
Make sure that the paper in the paper tray is
stacked evenly. If the stack is not even, paper
misfeeds will occur.
Problem Check Solution or cause