Operation Manual, MX-M266N-M316N ,GB

7-61
SYSTEM SETTINGS
Contents
• All Day "Energy Save Priority2": To be set when you
want Auto Power Shut-Off to be enabled in minimum
time in any time zone.
• 8:00-18:00 "Energy Save Priority1": To be set when
this machine is to be used more frequently in this time
zone than other time zones.
• 8:00-18:00 "Job Start Priority1": To be set when the
frequency of use of this machine in this time zone is
significantly more.
•
Settings edited to match the usage conditions, combining
the three patterns given above can also be selected.
Change transition time by time of day.
This function controls the transition to Auto Power
Shut-Off mode optimally for each time period by
analyzing the use of the machine based on job logs
obtained during a 4-week period.
Transition to Energy Saving and Auto Power
Shut-Off modes
* Factory default setting
Auto
This function controls the power optimally for each time
period by analyzing the use of machine based on job
logs obtained during a certain time period.
Manual
You can set a pattern for each time band.
The machine already has the 3-pattern template. The Energy
Save pattern can be added to the "Original Eco Patterns 1 to 4".
Three-pattern template
Display Messa ge When Extending Transition
Time to Preheat/Auto Power Shut-Off Mode
Set whether a message is displayed 15 seconds before
Preheat Mode or Auto Power Shutoff Mode is entered.
Sleep Mode Power Level
Set whether to give priority to Low Power or Fast Wake
Up.
Low Power: The machine switches to the power
saving mode, but it takes some time to
recover.
Fast Wake Up: Compared with Low Power, the power
value rises by a certain degree, but it
results in faster recovery.
• The image transfer control settings are not changed.
• This does not link to the Power On/Off Scheduling.
If both of them are enabled, the Power On/Off
Scheduling settings precede.
• Pages are counted for each paper size separately.
• When the power supply of the machine was off,
there was no job during this time.
Pattern
Transition
time
Average
outputs per
hour*
Mode1 (Job Start
Priority1)
After 1 hour 500 or more
Mode2 (Job Start
Priority2)
After 30
minutes
100 to 499
Mode3 (Energy
Save Priority1)
After 5 minutes 20 to 99
Mode4 (Energy
Save Priority2)
After the
minimum time
period
Up to 19
If the machine does not have the 4-week job log
information, the machine enters the template2 (Mode3
(Energy Save Priority1)) between 8:00 and 18:00
hours). Then after that, it enters (Mode4 (Energy Save
Priority2)).
Template Pattern Description of mode
Template1 All Day
"Energy
Save
Priority2"
The machine runs in the
"Mode4 (Energy Save
Priority2)" all the time.
Template2 8:00-18:00
"Energy
Save
Priority1"
The machine runs in
"Mode3 (Energy Save
Priority1)" between 8:00
and 18:00, and in "Mode4
(Energy Save Priority2)" at
other times.
Template3 8:00-18:00
"Job Start
Priority1"
The machine runs in
"Mode1 (Job Start
Priority1)" between 8:00
and 18:00, and in "Mode4
(Energy Save Priority2)" at
other times.