Operation Manual, MX-M266N-M316N ,GB

7-36
SYSTEM SETTINGS
Contents
Printer Settings
* When the hard disk drive is installed. (For U model, when the hard disk drive and the pirnter expansion kit are
installed.)
Image Send Settings
Item Factory default setting Page
■ Printer Settings
7-76
● Default Settings 7-76
 Prohibit Notice Page Printing Enabled 7-76
 Prohibit Test Page Printing Disabled 7-76
 A4/Letter Size Auto Change Varies depending on country and region 7-76
 Print Density Level 3 7-76
 Bypass Tray Settings 7-76
 Enable Detected Paper Size in Bypass Tray Disabled 7-76
 Enable Selected Paper Type in Bypass Tray Enabled 7-76
 Exclude Bypass-Tray from Auto Paper Select Disabled 7-76
 Job Spool Queuing* Enabled 7-76
 Disabling of USB Memory Direct Print* Disabled 7-76
● Interface Settings 7-77
 Hexadecimal Dump Mode* Disabled 7-77
 I/O Timeout 60 sec. 7-77
 Enable USB Port Enabled 7-77
 USB Port Emulation Switching* Auto 7-77
 Enable Network Port Enabled 7-77
 Network Port Emulation Switching* Auto 7-77
 Port Switching Method Switch at End of Job 7-77
Item Factory default setting Page
■ Image Send Settings
7-78
● Operation Settings 7-78
 Other Settings 7-78
 Default Display Settings Scan (fax when fax is installed)
7-78
• Hold settings for a while after scanning has been
completed
Disabled
 Address Book Default Selection Tab Switch: ABC, Address Type: All 7-78
 Image Orientation Portrait 7-78