Operation Manual, MX-M266N-M316N ,GB

1-4
BEFORE USING THE MACHINE
Contents
INTERIOR
(15) Toner cartridges
These contain toner for printing. When the toner runs out
in a cartridge, the cartridge must be replaced.
☞ REPLACING THE TONER CARTRIDGES (page 1-54)
(16) Upper right side cover
If a paper misfeed occurs while outputting to the job
separator or the finisher (sold separately), open this
cover to remove the misfed paper.
(17) Handle
Pull this out and grasp it when moving the machine.
(18) Fusing unit
Heat is applied here to fuse the transferred image onto
the paper.
(19) Paper tray right side cover
Open this to remove a paper misfeed in tray 2 to 4.
(20) Right side cover release lever
To remove a paper misfeed, pull and hold this lever up to
open the right side cover.
(21) Bypass tray
Use this tray to feed paper manually.
When loading a large sheet of paper, be sure to pull out
the bypass tray extension.
☞ LOADING PAPER IN THE BYPASS TRAY (page 1-36)
(22) Right side cover
Open this cover to remove a misfeed.
(23) Photoconductive drum
This is a drum with a photoconductor coating. The
images are produced on this photoconductor. (The
photoconductor is green.)
(15)
(18)
(22)(20) (21)(19) (23)
(16) (17)
Caution
The fusing unit is hot. Take care not to burn yourself
when removing a paper misfeed.
Do not touch or damage the photoconductive drum.
This may cause a defective image.