M200D Operation-Manual Printer Scanner GB

Table Of Contents

SYSTEM SETTINGS

The system settings allow the administrator of the machine to enable and disable functions to suit the needs of the

workplace. This chapter explains system settings for the printer and scanner functions. For system settings that are

common to all modes, see the "System settings guide".

SYSTEM SETTINGS LIST

The system settings for the printer and scanner functions are shown in the following table. Factory default settings

are indicated in bold. When "ENABLE, DISABLE" appears in the "Settings" column of a program, the program is

enabled by pressing the [OK] key so that a checkmark appears in the checkbox. A checkmark in the checkbox ( )

indicates that "ENABLE" is selected. No checkmark ( ) indicates that "DISABLE" is selected.

For the initial administrator password set at the factory, see "PROGRAMMING AN ADMINISTRATOR

PASSWORD" in the "System settings guide".

Mode System settings Settings Explanation

Printer NOTICE PAGE ENABLE, DISABLE Select whether or not a Notice Page is printed

when printing is not successful due to a

memory full (or other) error.

FORCED OUTPUT OF

ENABLE, DISABLE When no tray has the specified size of paper,

this setting is used to select whether or not

the print job will be printed on the closest size

of paper.

Scanner DISABLE USB SCAN YES, NO Select whether or not scanning from a

computer and scanning from the machine are

disabled. When "YES" is selected, USB

scanning is disabled.