MX-M850/M950/M1100 Operation-Manual Maintenance-Guide GB

46
REMOVING A STAPLE JAM
6
Return the lever to its original position.
7
Install the staple case.
Push the staple case in until it
clicks into place.
8
Turn the knob until the unit faces down.
9
Push in the unit.
10
Close the cover.
SADDLE UNIT / FINISHER (FOR MX-M850) / SADDLE
STITCH FINISHER
To remove or reinsert the staple case, see "SADDLE UNIT" (page 11) or "FINISHER (FOR MX-M850) / SADDLE
STITCH FINISHER" (page 13).
1
Lower the lever at the front end of the
staple case and remove the jammed
staple.
Remove the leading staple if it
is bent. If bent staples remain, a
staple jam will occur again.
2
Return the lever to its original position.