MX-M850/M950/M1100 Operation-Manual Maintenance-Guide GB

13
REPLACING THE STAPLE CARTRIDGE
FINISHER (FOR MX-M850) / SADDLE STITCH FINISHER
1
Open the cover.
2
Pull out the unit.
Slowly pull out the unit until it
stops.
3
Remove the staple case.
Staple section
Grasp the green part of the
staple case and pull the staple
case down.
Saddle stitch section
(1) Grasp the green part and
pull it forward and down.
The unit that holds the
staple case will move
forward.
(2) Pull the staple case up
and out.
4
Release the staple case cover lock.
While holding both sides of the
staple case, pull up the upper
unit.
5
Remove the staple cartridge.
6
Install a new staple cartridge.
Push the staple case in until it
clicks into place.
In the saddle stitch section, replace the cartridges in
the front and back staple cases (two cartridges).
(1)
(2)
When staples remain, the lock cannot be released.
Do not remove the seal from the cartridge before
inserting the cartridge into the case.