MX-M850/950/1100 Operation-Manual Maintenance-Guide GB

38
REMOVING MISFEEDS
X Trays 1 to 4
Before pulling the tray out, be sure to verify that a misfeed has not occurred in the paper conveyor. If you pull the tray out
without checking, you may tear misfed paper and make it more difficult to remove the pieces that remain in the machine.
☞ Transport area (page 37)
1
Pull out trays 1 and 2.
Gently pull out the tray until it
stops.
2
Remove the misfed paper.
A misfeed has occurred inside
the machine. Look inside to
check.
3
Remove the misfed paper from tray 1.
4
Remove the misfed paper from tray 2.
After removing the paper, close
trays 1 and 2.
5
Pull out tray 3.
Gently pull out the tray until it
stops.
6
Lift the unit up off the tray.
Place the unit on a level surface.
7
Remove the misfed paper.
A misfeed has occurred inside
the machine. Look inside to
check. (Do not touch the metal
frame.)
8
Place the unit on the frame.
After placing the unit on the
frame, close tray 3.
9
Remove the misfeed from tray 4.
Follow the same procedure (steps 5 to 8) as for tray 3.