MX-M850/950/1100 Operation-Manual Maintenance-Guide GB

15
REPLACING THE STAMP CARTRIDGE
When the stamp on scanned originals becomes faint, replace the stamp cartridge (AR-SV1).
* When the stamp unit (AR-SU1) is installed on the automatic document feeder
1
Open the automatic document feeder.
2
Remove the document backplate sheet.
Gently remove the sheet.
After removing the sheet, place
it directly on the document
glass. (Align the far left corner of
the sheet with the mark on
the document glass.)
3
Pull out the stamp unit.
Grasp the knob as shown and
pull forward.
4
Remove the stamp cartridge (A).
5
Install the new stamp cartridge.
6
Push the stamp unit firmly back in.
Push the stamp unit in until it
clicks into place.
7
Close the automatic document feeder
to attach the document backplate
sheet.
When the automatic document
feeder is closed, the document
backplate sheet on the
document glass attaches to the
automatic document feeder.
8
Close the automatic document feeder.
If the document backplate sheet
is not completely attached,
remove it and then repeat
step 7.
(A)