Operation Manual, Software Setup Guide

42
Troubleshooting
Problem with Windows
! Cannot detect this machine
CHECK1
Is your computer connected to the same network as this machine?
Countermeasure
The computer and this machine must be connected on the same LAN
to be detected. When they are connected to a dierent subnetwork,
click the [Specify conditions] button and input the name of this
machine (host name) or IP address and search again.
CHECK2
Are the computer and machine connected correctly?
Countermeasure
Check whether the LAN connector of the computer and this machine is
connected correctly. Also check the hub side of the LAN cable.
⇒
"How to connect this machine P.11"
CHECK3
Is the power turned on for the printer?
Countermeasure
If the printer is not turned on, it will not be detected. If the printer is
not on, use the main power switch, then the [Power] key to turn the
power on to search the machine again.
! The options and peripherals of this machine could not be automatically setup
CHECK
If automatic setup of the options and peripherals is not possible, setup manually.
• To setup the options
⇒
Enable options and peripherals P.28
Countermeasure
Check the status of the attached peripherals following the steps below and setup the
options.
1) Print the "All Custom Setting List" in this machine's settings, and check the settings
for peripheral devices and trays.
To print the "All Custom Setting List", tap the [Settings] key, and then tap the [Status]
tab
→
[List Print (User)]
→
[All Custom Setting List].
[Paper Feeder Options] sets the number of trays for the machine.
2) For [Paper Tray Settings], [Paper Type Registration] and [Tandem Connection
Setting], click the respective button and check the setting details.
Tray Registration: In the machine's system settings, the settings in [Paper Tray
Settings] are applied. Specify the paper size and type which has been set for each
tray.
Paper Type Registration: In the machine's system settings, the settings in [Paper
Type Registration] are applied. If the name of a user type has been changed, enter
the new name.
Tandem Connection Setting: In the machine's system settings (for Administrator),
enter the setting (client IP address) for [Device Control]
→
[Tandem Connection
Setting]. [Tandem Connection Setting] can be set by selecting [LPR Direct Print
(Specify Address/Auto Search)] in the [Custom installation] screen (only when
installed).