Operation Manual, Setup Guide for the Administrator

7
4) A test patch is printed.
Note:
When the printing of a test patch fails, the following
message appears: Printing test patch has failed. Use
A4 or 8 1/2" X 11" paper for this adjustment. Press
[Execute] to print the test patch.
5) Place the test patch on the document glass and tap the
[Execute] key to start the adjustment.
Note:
When the scanning of the test patch fails, the
following message appears: Auto adjustment has
failed. Please check if the test patch is properly set on
the document glass. Press [Execute] to resume
scanning.
6) When the adjustment is completed, a completion
message appears and the adjustment result is printed.
Note:
When the printing of the adjustment result fails, the
following message appears: Printing adjustment
result has failed. Use A4 or 8 1/2" X 11" paper. Press
[Execute] to print the adjustment result.
7) Tap the [Back] key to return to the Laser Adjustment
screen.
Note:
It is recommended to perform Auto Adjustment
several times. (2 to 3 times)
8) Make sure to perform [1.4.3 User Calibration] under
[Settings] if you wish not to erase the adjustment
values set by [1.4.1 Engine Grey Balance Adjustment]
and [1.4.2 Printer Grey Balance Adjustment]) after this
adjustment. Make sure to choose both the copy and
printer calibrations in the calibration.
1.1.2 Density Smoothing Adjustment
(Densitometer Adjustment)
This performs density smoothing adjustment for printing in
front / rear (main scan) direction by measuring test patch
with a densitometer.
Note:
The densitometer is to be prepared by users.
1) Select [Density Smoothing Adjustment (Densitometer
Adjustment)] in the Laser Adjustment screen.
2) To print a test patch, tap the [Execute] key in the
Density Smoothing Adjustment (Densitometer
Adjustment) screen. If you need to change the density,
select the desired density and then tap the [Execute]
k ey.
Note:
To return your preferences to the factory defaults, tap
the [Return to the Defaults] key. When a confirmation
message appears, tap the [OK] key. The machine
reboots to return to the factory defaults.