Operation Manual, Setup Guide for the Administrator

24
3.4.2 Punch Mode Switch
This switches punch operation mode.
High Accuracy Mode: Prioritizes punch position accuracy
when punching.
High Production Mode: Prioritizes speed when punching.
1) Select [Punch Mode Switch] in the Punch Module
screen.
2) Select [High Accuracy Mode] or [High Production
Mode] for punch mode.
Default: [High Production Mode]
Note:
Select [High Accuracy Mode] when punch hole is skewed
against paper.
3) Tap the [Register] key to switch to the desired mode.
3.4.3 Punch Operation Skew Adjustment
This performs skew (paper tilt) adjustment for punch in
High Accuracy Mode.
Perform this adjustment when the punch hole is skewed
against paper in high accuracy mode.
1) Select [Punch Operation Skew Adjustment] in the
Punch Module screen.
2) Adjust the paper jog amounts for the paper skew
adjustment in high accuracy mode.
The 10-key pad appears when each of the textboxes is
tapped. Enter the desired values.
Input range: [80] to [120] (1 = 0.1 mm)
Default: [100] for each
3.5 Folding Unit
Select [Folding Unit] in the Peripheral Adjustment screen.
3.5.1 Saddle Fold Position Adjustment
This performs adjustment of fold position for saddle fold.
1) Select [Saddle Fold Position Adjustment] in the Folding
Unit screen.
2) Adjust the saddle fold position for when the folding unit
is installed.
The 10-key pad appears when the textbox is tapped.
Enter the desired value.
Input range: [46] to [54] (1 = 0.5 mm)
Default: [50]
Diagram showing the saddle fold position