Operation Manual, Setup Guide for the Administrator

23
Note:
Staple position in paper feed direction cannot be
adjusted.
Functional Restriction
For 2 staples, the staple positions that can be adjusted
vary depending on the paper size and the number of
sheets included in a set to be stapled as the following table
shows:
Paper size Number of
sheets
included in
a set
Staple position that
can be adjusted
A4R/Letter R or
smaller
20 sheets or
less
Only the staple at back
More than 20
sheets
Both staples at front
and back
Larger than
A4R/Letter R
-
Both staples at front
and back
3.3.2 Paper Alignment Width Adjustment for
Staple Position
This performs jogger width adjustment for staple (paper
width direction).
1) Select [Paper Alignment Width Adjustment for Staple
Position] in the Finisher screen.
2) Adjust the distance between the alignment plates in the
direction of paper width for stapling.
The 10-key pad appears when the textbox is tapped.
Enter the desired value.
Input range: [50] to [150] (1 = 0.1 mm)
Default: [100]
3.4 Punch Module (When the 100-sheet
saddle finisher and the punch module
for the finisher is installed)
Select [Punch Module] in the Peripheral Adjustment
screen.
3.4.1 Punch Position Adjustment
This performs adjustment of punch position from paper
edge or in the direction of paper width.
1) Select [Punch Position Adjustment] in the Punch
Module screen.
2) Adjust the hole positions in relation to the lead edge
and in the direction of paper width.
The 10-key pad appears when the textbox is tapped.
Enter the desired value.
Sub Scan Direction:
Input range: [50] to [150] (1 = 0.1 mm)
Default: [100]
Main Scan Direction:
Input range: [85] to [115] (1 = 0.1 mm)
Default: [100]