Operation Manual, Setup Guide for the Administrator

22
3.1.6 Paper Alignment Width Adjustment for
Saddle Stitch/Saddle Fold
This performs jogger width adjustment for saddle stitch
and saddle fold.
Set this adjustment when the stapled stuck of paper is not
aligned.
1) Select [Paper Alignment Width Adjustment for Saddle
Stitch/Saddle Fold] in the Saddle Finisher screen.
2) Adjust the distance between the alignment plates in the
direction of paper width for saddle stitching/saddle
folding.
The 10-key pad appears when the textbox is tapped.
Enter the desired value.
Input range: [80] to [120] (1 = 0.20944 mm)
Default: [100]
3.2 Trimming Module
Select [Trimming Module] in the Peripheral Adjustment
screen.
3.2.1 Trimming Original Point Adjustment
This performs adjustment of trimming origin position for
saddle stitch (fold and staple).
This corrects deviation of the actual cutting amount from
the amount set with the trimming setting.
1) Select [Trimming Original Point Adjustment] in the
Trimming Module screen.
2) Adjust the trimming original point for saddle stitching.
The 10-key pad appears when each of the textboxes is
tapped. Enter the desired values.
Input range: [50] to [150] (1 = 0.1 mm)
Default: [100] for each
3.3 Finisher (When the 100-sheet finisher is
installed)
Select [Finisher] in the Peripheral Adjustment screen.
3.3.1 Staple Position Adjustment
This performs staple position adjustment for staple in the
direction of paper width.
1) Select [Staple Position Adjustment] in the Finisher
screen.
2) Adjust the staple positions in the direction of paper
width.
The 10-key pad appears when each of the textboxes is
tapped. Enter the desired values.
Input range:
One staple: [70]-[130] (1 = 0.1 mm)
Two staples: [85]-[115] (1 = 0.1 mm)
Default: [100] for each