Operation Manual, Setup Guide for the Administrator

20
3 Peripheral Adjustment
Select [Peripheral Adjustment] in the Machine Adjustment
screen.
Adjustable options:
The saddle finisher, trimming module, finisher, punch
module, and folding unit can be adjusted:
The installed options are displayed as follows:
 When the 100-sheet saddle finisher, trimming module
and punch module are installed:
3.1 Saddle Finisher (When the 100-sheet
saddle finisher is installed)
3.1.1 Staple Position Adjustment
This performs staple position adjustment in the direction of
paper width.
1) Select [Staple Position Adjustment] in the Saddle
Finisher screen.
2) Adjust the staple positions in the direction of paper
width.
The 10-key pad appears when each of the textboxes is
tapped. Enter the desired values.
Input range:
One staple: [70] to [130]
Two staples: [85] to [115] (1 = 0.1 mm)
Default: 100 for each
Note:
Staple position in paper feed direction cannot be
adjusted.
Functional restriction
For 2 staples, the staple positions that can be adjusted
vary depending on the paper size and the number of
sheets included in a set to be stapled as the following table
shows:
Paper size Number of
sheets
included in
a set
Staple position that
can be adjusted
A4R/Letter R
or smaller
20 sheets or
less
Only the staple at back
More than 20
sheets
Both staples at front
and back
Larger than
A4R/Letter R
-
Both staples at front
and back