Operation Manual, Setup Guide for the Administrator

17
2.2.2 Feed Direction Print Position Adjustment
(Registration Motor On Timing)
This performs print start position adjustment for printing.
1) Select [Feed Direction Print Position Adjust.
(Registration Motor On Timing)] in the Edge Adjustment
screen.
2) Enter the desired values and tap the [Register] key.
The input range is [20] to [80] (1 = 0.1 mm) and the default
is [50] for each.
Note:
[Bypass], [LCC] and [LCT] are displayed only when
the options are installed.
2.2.3 Scan Original Edge Adjustment (Duplex
Single Pass Feeder)
This performs edge (scanning start) position adjustment
for scanning original from document feeder.
1) Select [Scan Original Edge Adjustment (Duplex Single
Pass Feeder)] in the Edge Adjustment screen.
Specify the Print Position Adjustment first.
2) Enter the desired values and tap the [Register] key.
Input range: [20] to [80] (1 = 0.1 mm)
Default: [50] for each
Note:
To return your preferences to the factory defaults, tap
the [Return to the Defaults] key. When a confirmation
message appears, tap the [OK] key. Your preferences
are returned to the factory defaults and the screen
returns to the Edge Adjustment screen.
2.3 Void Area Adjustment
Select [Void Area Adjustment] in the Image
Position/Ratio/Area Adjustment screen.
2.3.1 Copy Image Loss Amount Settings
This performs adjustment of image loss amount for
scanning original in copy mode.
1) Select [Copy Image Loss Amount Settings] in the Void
Area Adjustment screen.
Specify the Print Position Adjustment first.
2) Enter the desired values and tap the [Register] key.
Input range: [0] to [99] (1 = 0.1 mm)
Defaults:
Edge image loss amount setting: [30]
Side image loss amount setting: [20]
Note:
To return your preferences to the factory defaults, tap
the [Return to the Defaults] key. When a confirmation
message appears, tap the [OK] key. Your preferences
are returned to the factory defaults and the screen
returns to the Void Area Adjustment screen.