Service manual

MX-FNX1/MX-PNX1 DISASSEMBLY AND ASSEMBLY 6 – 7

8) Remove the alignment plate. Remove the screws and the

pawl, and remove the process tray.

9) Slide the unit and remove the alignment motors F and R.

(2) Empty sensor, alignment plate HP sensors F and R

1) Remove the inner finisher from the main unit. Refer to A-(1).

2) Remove the inner cover. Refer to A-(2).

3) Remove the tray unit. Refer to B-(10).

4) Remove the process tray unit. Refer to C-(1).

5) Remove the bracket and the empty sensor. Remove the align-

ment plate HP sensors F and R.

D. Staple section

(1) Staple cartridge

1) Open the front cover, and slide the inner finisher. Refer to B-

(1).

2) Release the lock, and remove the staple cartridge.

(2) Staple unit

1) Remove the inner finisher from the main unit. Refer to A-(1).

2) Remove the inner cover. Refer to A-(2).

3) Remove the latch cover. Remove the parts and the shaft.

4) Remove the screw from the bottom. Remove the staple unit,

and disconnect the connector.