Service manual

MX-FNX1/MX-PNX1 OPERATIONAL DESCRIPTIONS 5 – 5

2. General

This chapter describes operations of the inner finisher. The major operation modes are as follows:

• Non-sort mode

• Offset mode

• Staple mode

• Non-sort mode + punch

• Offset mode + punch

• Staple mode + punch

In this chapter, the basic operations of the non-sort mode, the offset mode, and the staple mode are described.

3. Outline of the transport path

The outline of the path is shown below.

No. Name No. Name

1 Tray 9 Punch pin

2 Bundle exit roller 10 Paper rear edge sensor (FPPEND)

3 Paddle 11 Main unit paper exit roller

4 Alignment plate 12 Stapler

5 Paper exit roller 13 Paper stopper

6 Take-up belt 14 Empty sensor (FSTPD)

7 Inlet port sensor (FED) 15 Paper holding lever

8 Inlet port roller

1345678910

1112131415