Specifications

- 8 -
USER PROGRAMS FOR THE
NETWORK EXPANSION KIT
When the network expansion kit is installed in the machine, the following programs are added to the user programs
for Print mode.
The IP address and other network settings are configured using these user programs.
Additional user programs for Print mode
The procedure for selecting a user program setting is explained in "SELECTING A SETTING FOR A USER
PROGRAM" in the operation guide for the machine.
Note
Program
number
Program name
Settings (factory default
settings appear in bold)
Explanation
4 ENABLE TCP/IP 1: YES
2: NO
This program must be enabled to use the
machine on a TCP/IP network. "IP ADDRESS
SETTING" must also be configured.
This program is initially enabled (factory default
setting).
5 ENABLE DHCP 1: YES
2: NO
If "YES" is selected (factory default setting) and
the machine is connected to a TCP/IP network,
the IP address will be acquired automatically.
If you will manually assign an IP address using
"IP ADDRESS SETTING", select "NO".
6 IP ADDRESS
SETTING
• IP ADDRESS
• SUBNETMASK
•DEFAULT GATEWAY
This program is used to set the IP address (IP
address, Subnet Mask, and Gateway) of the
machine when TCP/IP protocol is used on the
network.
When "ENABLE DHCP" is selected, the machine
will obtain an IP address automatically. This is
the factory default setting.