Specifications

- 65 -
USING THE NETWORK SCANNER FUNCTION
8
Press the [OK] key and then [ ] key
( ) or [ ] key ( ) to select the
colour mode (COLOUR, GRAY and
B/W) and exposure level.
(When B/W mode is selected.)
Press the [EXPOSURE
( )] key to select the
original type.
The original image type
changes as follows each
time the [EXPOSURE
( )] key is pressed:
"AUTO" ( ) → "TEXT"
() → "PHOTO" ( ).
If needed, adjust the
exposure level for TEXT
() or PHOTO ().
For a darker image, press
the [ ] key ( ). For a
lighter image, press the
[ ] key ( ).
(When COLOUR or GRAY mode is selected.)
Adjust the exposure level.
For a darker image, press
the [ ] key ( ). For a
lighter image, press the
[ ] key ( ).
9
Press the [START] key ( ) to begin
scanning.
TEXT
| | | | |
TEXT
| | | | |
| | | | |
• The [CLEAR] key ( ) can be pressed during a scanning operation to return to the previous step of the
operation. To cancel a scanning operation and return to the initial state of scanner mode, press the [CLEAR
ALL] key ( ).
• The network scanner function cannot scan both sides of an original placed in the RSPF.
• The scan settings stored in a scan mode cannot be edited if the scan mode has been selected for a
destination. You can either store the desired settings in a new scan mode as explained in "STORING
SCANNING SETTINGS - Network Scanning" (p.54) and then edit the destination settings, or you can cancel
the selection of the scan mode for the destination and then edit the scan mode settings.
• Before performing Scan to E-mail, read "IMPORTANT POINTS WHEN USING SCAN TO E-MAIL"
(p.72). Take care that the image file is not too large.
• A limit for the size of image files that can be sent using Scan to E-mail can be set in "Maximum Size of
E-mail Attachments"
(p.61) of the Web page.
Note
Caution