Specifications

M
M
X
X
-
-
M
M
1
1
1
1
0
0
0
0
/
/
9
9
5
5
0
0
/
/
8
8
5
5
0
0
S
S
a
a
l
l
e
e
s
s
G
G
u
u
i
i
d
d
e
e
Confidential (Ver. 0.5)
20
 Developer Cooling System unit for better image quality
The MX-M1100/M950/M850 forced-air cooling system
for the developer unit helps prevent excessive heat
build-up to keep image quality stable even in
high-volume environments.
 Non-Detachable Maintenance (full front access to all the key
components of the machine)
This design makes service and general maintenance of the
MX-M1100/M950/M850 easy by allowing technicians to slide out
main units without the need to disassemble the entire machine to
adjust or exchange sub-components.
This helps to maintain maximum machine uptime
 Stamp unit marks already scanned documents for checking
Although there is a Multi-Feed Detection Sensor in DSPF, users may wish to get evidence that all their
documents have been scanned without any problems. (e.g. in case of important fax sending, or paper
document digitalisation )
The stamp unit allows to check which documents have already been scanned, and in case of a duplex
original, the marks are stamped twice on the front side of document.
 DSPF with simple ‘Original sheet pass’ and ‘Slow scan mode’
Compared to the Auto Document Feeder, the DSPF has a simple ‘Original sheet pass’. Therefore it can
reduce any possible document jam and thus shorten the machine downtime and cause less damage in
the originals
Furthermore, MX-M1100/M950/M850 has ‘Slow scan mode’ for scanning small (thin) documents.
This further increases the machine reliability.
38g/m2 – 49g/m2 documents
can be scanned by DSPF.
Although the name is ‘Slow
Scan’, the scan speed is 80
opm
(faster than in MX-M700)
Air-cooling system
Because ‘Original ……
sheet pass’ is very
simple, Paper jam
incidents are easily
reduced
Slow Scan Mode