Specifications
Table Of Contents
- INTRODUCTION
- CONTENTS
- USING THE MANUAL
- DIFFERENCES BETWEEN MODELS
- BEFORE USING THE MACHINE
- PRINTER
- TROUBLESHOOTING
- ROUTINE MAINTENANCE
- SYSTEM SETTINGS
- WEB FUNCTIONS IN THE MACHINE
- ABOUT THE WEB PAGES
- ABOUT THE WEB PAGES (FOR USERS)
- CONFIGURING THE PRINTER CONDITION SETTINGS
- ABOUT THE WEB PAGES (FOR THE ADMINISTRATOR)
- CONFIGURING SMTP AND DNS SERVER SETTINGS
- PROTECTING INFORMATION PROGRAMMED IN THE WEB PAGE ([Passwords])
- ADMINISTRATOR SETTINGS
- E-MAIL STATUS AND E-MAIL ALERT SETTINGS
- TRADEMARK ACKNOWLEDGMENTS
75
TROUBLESHOOTING
3
Take out the new toner cartridge. Shake it vertically five or six times.
4
Insert the toner cartridge along the guides until it locks in place.
If there is any dirt or dust on the toner cartridge, remove it before installing the
cartridge.
5
Press the centre of the toner cartridge until the cartridge locks into place.
6
Close the front cover.
The message will be cleared and printing will be possible.
When holding the toner cartridge, do not grasp the shutter. This may
cause toner to leak.
A toner cartridge of a different colour cannot be installed. Be sure to
install a toner cartridge of the same colour.
• Even after a new toner cartridge is installed, the message may still appear, indicating that printing cannot be
resumed (toner is not fed sufficiently). In this case, open and close the front cover. The machine will feed toner
again for about two minutes and then printing can be resumed.
• Before closing the front cover, make sure that the toner cartridge is correctly installed.
• When closing the front cover, gently hold both ends.
Caution
Note
Note