Operation Manual

7-111
SYSTEM SETTINGS►SYSTEM SETTINGS
[AB sizes]
Measure the length of (a-1) in mm. Divide 10000 by the measured length of (a-1), and enter that value in [Y] for the Side 1.
Measure the length of (b-1) in mm. Divide 10000 by the measured length of (b-1), and enter that value in [X] for the Side 1.
[Inch sizes]
Measure the length of (a-2) in inches. Divide 500 by the measured length of (a-2), and enter that value in [Y] for the Side 1.
Measure the length of (b-2) in inches. Divide 500 by the measured length of (b-2), and enter that value in [X] for the Side 1.
(3) Tap [OK].
(4) Return to step 1 and check the result of adjustment.
If the size has deviated as a result of adjustment, repeat adjustment until the deviation is eliminated.
Side 1/2, XY Print Position Settings
The Side 1/2, XY Print Position Settings are used to make the centres of the Side 1 and Side 2 print positions match to
remove printing misalignment.
Tap the [Change] button in Side 1/2, XY Print Position Settings to display the advanced settings screen of Side 1/2, XY
Print Position Settings.
(1) Select the units used in the Side 1/2, XY Print Position Settings
Tap [mm] to select the units used for the settings.
(2) Print a test pattern
Before starting, print a test pattern from [Test Print] in Side 1/2, XY Print Position. One page of patterns for settings are printed
by duplex printing.
For information on the measurement patterns, refer to "Measurement patterns for Side 1/2, XY Ratio Settings/Side 1/2, XY Print
Position".
(3) Read the scale from the patterns and enter the values.
Fold the sheet in half with the centre in the horizontal and vertical direction as folding lines respectively and put creases at both
ends, then unfold to return.
Measure the crease position of X and Y by scale for Side1 and Side2 respectively and input the values.
If the values of both ends are different, the average value should be input.
Measurement Line
(Measurement Marker)
Length specified by measurement line interval
Assistant Line 50 mm (1.969 inch)
100 mm
5 inch
• If the print position has shifted due to these settings, configure the Side 1/2, XY Print Position Settings.
• The Side 1/2, XY Ratio Settings can only be used when the machine is used as a printer.
Y
X