Operation Manual

8-136
SYSTEM SETTINGS►SYSTEM SETTINGS
Status Indicator will blink if data is received
Specify whether or not the status indicator blinks when a fax or Internet fax is received.
Total Setting for Finish
Select the finish setting. Set whether finishing positions are specified on the specified paper or on the original.
Paper Weight Setting
These are used to control the toner fusing temperature according to the weight of the paper.
These settings apply to plain paper, recycled paper, punched paper, pre-printed paper, letterhead paper, coloured
paper, and user type paper.
You can select "60g/m
2
to 89g/m
2
" or "90g/m
2
to 105g/m
2
" ("16 to 23 lbs." or "23+ to 28 lbs.").
Data List
To specify [One Sided] or [Two Sided] printing in Data List.
Disabling of Duplex
This is used to disable 2-sided printing, such as when the duplex module malfunctions.
Disabling of Offset
Disable offset output.
Disabling of Stapler
This setting is used to prohibit the use of staple, such as when the staple of finisher or saddle sticth finisher
malfunctions.
Disabling of Punch
This setting is used to prohibit the use of punch, such as when the punch module of finisher or saddle stitch finisher
malfunctions.
Disabling of Colour Mode
When a colour-related problem has occurred and printing is not possible, the use of colour mode will be temporarily
blocked.
Disabling of Document Feeder
Use this setting to prohibit the use of the automatic document feeder, such as when the feeder malfunctions. (When the
setting is enabled, scanning is still possible using the document glass.)
Disabling of Large Capacity Cassette
This setting is used to disable the large capacity cassette, such as when it malfunctions.
Red
indicator
(Error
indicator)
Errors that do not stop machine
operation, such as almost out of
toner.
Red: Light up Red: Light up Red: Light up
Errors that stop machine
operation, such as misfeeds and
out of toner.
Red: Blink Red: Blink Red: Blink
The machine is in a status other
than the above.
Red: Off Red: Off Red: Off
This can only be set on the machine's operation panel.
Be sure to use only paper that is in the same weight range as the weight range set here. Do not mix plain or other paper that
is outside the range with the paper in the tray.
When settings are changed, the changes will take effect after the machine is restarted. To restart the machine, see
"TURNING ON THE POWER (page 1-10)
".
Status Pattern 1 Pattern 2 Pattern 3