Setup guide
Table Of Contents
- TABLE OF CONTENTS
- ABOUT THIS MANUAL
- BEFORE USING THE MACHINE AS A NETWORK SCANNER
- ENTERING DESTINATIONS
- BASIC PROCEDURE FOR TRANSMISSION IN SCAN MODE
- SCANNING TO E-MAIL, FTP, DESKTOP, AND NETWORK FOLDER
- CHANGING THE EXPOSURE AND EXPOSURE MODE
- CHANGING THE RESOLUTION
- AUTOMATICALLY SCANNING BOTH SIDES OF AN ORIGINAL (2-Sided Original)
- SPECIFYING THE ORIGINAL SCAN SIZE AND SEND SIZE (Enlarge/Reduce)
- CHANGING THE COLOUR MODE
- CHANGING THE FILE FORMAT
- CHANGING THE SUBJECT, FILE NAME, REPLY-TO, AND MESSAGE
- BASIC PROCEDURE FOR SCANNING IN USB MEMORY MODE
- BASIC PROCEDURE FOR TRANSMISSION IN INTERNET FAX MODE
- CHECKING THE STATUS OF TRANSMISSION/RECEPTION JOBS
- CONVENIENT FUNCTIONS
- SENDING THE SAME IMAGE TO MULTIPLE DESTINATIONS (Broadcast Transmission)
- ERASING PERIPHERAL SHADOWS ON THE IMAGE (Erase)
- SCANNING AN ORIGINAL AS TWO SEPARATE PAGES (Dual Page Scan)
- SENDING AN IMAGE AT A SPECIFIED TIME (Timer Transmission)
- WHITENING FAINT COLOURS IN THE IMAGE (Suppress Background)
- SCANNING BOTH SIDES OF A CARD ONTO A SINGLE PAGE (Card Shot)
- SCANNING MANY ORIGINALS AT ONCE (Job Build)
- SCANNING ORIGINALS OF DIFFERENT SIZES (Mixed Size Original)
- SCANNING THIN ORIGINALS (Slow Scan Mode)
- STORING SCAN OPERATIONS (Programs)
- FORWARDING A RECEIVED INTERNET FAX TO AN E-MAIL ADDRESS (Inbound Routing Settings)
- INTERNET FAX FUNCTIONS
- SCANNING FROM A COMPUTER (PC SCAN MODE)
45
SCANNING TO USB MEMORY
Follow the steps below to send a scanned file to a commercially available USB memory device that has been connected
to the machine. This stores the file in the USB device.
4
BASIC PROCEDURE FOR
SCANNING IN USB MEMORY
MODE
• Consult your dealer or retailer for USB memory devices that can be used.
• When a default address is configured in "Default Address Setting" in the system settings (administrator), the mode cannot
be changed. To switch to USB memory mode, touch the [Cancel] key in the touch panel and then follow the steps below.
1
Connect the USB memory to the USB
connector (Type A) on the machine.
System Settings: USB-Device Check
This is used to check the connection of a USB device to the machine.