Operation Manual, User's Manual

1-167
BEFORE USING THE MACHINE►MAINTENANCE
8
Clean the laser unit.
(1) Point the cleaner down and slowly insert
the tool into the hole that you wish to
clean.
Be sure to point the cleaner down.
Labels similar to (A) are attached to areas that require
cleaning.
(2) Insert the cleaning tool all the way into
the hole and then pull it back out.
Pull the cleaning tool out until you feel the tip of the tool
leave the cleaning surface of the laser unit.
(3) Repeat step 2 two or three times and then
remove the cleaning tool.
9
Repeat steps 8 to clean all holes (4
holes) in the laser unit.
The laser unit is cleaned in four locations, including the
location cleaned in step 8. Clean all holes.
10
Replace the cleaning tool.
(1) Engage the cleaning tool onto the boss
and turn it around it, and then put the
edge (the cleaner side) on the left hand
hook.
(2) Put the right-hand side of the cleaning
tool over the hook to place it on the near
side.
(3) Turn the cleaning onto hook.
(A)
Cleaning locations
Boss
(2)
(3)