User`s guide

... and Windows CE

Appendix

The following text is also provided as the Readme.tx file together with the software:

Readme.txt for installation of ORiNOCO/IEEE driver on WinCE 2.0

===============================================================

The installation consists of the following files :

SETUP.EXE : Installation file for setup of ORiNOCO/IEEE driver on WinCE.

README.TXT : This readme.txt file

NETSETUP.EXE :Installation of additional network files for some CE-devices (normally

provided on the installation disk that comes with the H/PC product)

SETUP.EXE

=========

Run this file from the explorer on your desktop or by using the RUN command from the

taskbar. This setup will install all necessary files needed to install the ORiNOCO/IEEE driver

on your WinCE-device. It will install the files into your 'Windows CE Services' directory. The

files will be installed on the CE-Device directly, if already connected, or when the device is

connected onto your desktop.

NETSETUP.EXE

=============

On some CE-devices the networking files are not include on the device. To check this, open

the "ControlPanel" and look for the "Network" icon. If this is missing then the netsetup.exe

should be installed first. This installation will add the 'WinCE 2.0 Additional Network

Components' that may or may not have been pre-installed on the Windows CE 2.0 H/PC. If

your H/PC does not come pre-installed with the network components, they are usually

included with the software shipped with the H/PC. It will install the files into your 'Windows CE

Services' directory. The files will be installed on the CE-Device directly, if already connected,

or when the device is connected onto your desktop. On some device it is necessary the do a

"RESET" of the device. This can be done by the reset button at the bottom of the device.

(Look for this in the WindowsCE manual)

To install the WinCE drivers notice the following:

==================================================

Windows CE version:

------------------

At this moment we support Windows CE 2.0. and Windows CE 2.11

Get type of processor used on CE device:

-----------------------------------------

Select open "Control Panel" on CE-device, double-click "System Properties" and under

System the device will show which processor is used. At this moment only MIPS and SH3 is

supported.

Version of ORiNOCO/IEEE NIC:

----------------------------

The Serial number must be higher than : 98UT08333219. (Serialnumber on label on

the back of the ORiNOCO/IEEE card). This says that the version of the NIC is Variant 1,

Version 1.256 or higher. This information can be shown with Wavemanager/Client on a

desktop machine or laptop.