User guide

32 CHAPTER 4. CDPD CONNECTIVITY
Configuring the PM100C
1. Insert your PM100C into the PCMCIA slot with the power turn off. Make sure
that your computer is on already and are running Windows 95.
2. Turn on the modem and wait for your PC to recognize that the PM100C has been
activated.
3. Windows 95 will detect the presence of your new modem and prompt you for
hardware drivers. Insert the diskette ”PM100C Utilities for Windows 95, Disk 1
0f 2” and select Driver from disk provided by Hardware manufacturer and then
click OK.
4. Click OK to load the driver.
5. Enter your area code and then click OK.
6. Launch the Progtool application. Select Start, Programs, PM100C, and then
highlight Progtool.
7. Enter the IP address provided by your CDPD carrier in Field 1 (NEI List). For
Example : 166.128.4.60
8. In API box, select SLIP
9. In the Registration box, select Automatic
10. Channel Set : A Prefered
11. In Sleep box, select Enable to reduce battery drain when modem is not in use.
12. Click save button to save your selections.
13. To verify your configuration, click on Monitor (Start, Programs, PM100C).
14. Click on Connect. The connected indicator should darken.
4.6 Windows NT CDPD Modem Integration