User guide

26 CHAPTER 4. CDPD CONNECTIVITY
• HP 320LX (WCE 1.0 or WCE 2.0)
• Casio Cassiopeia (WCE 1.0)
• Compaq Companion (WCE 1.0)
4.4.2 Motorola 100C with WCE 2.0
You need to configure the WCE 2.0 device to use the SLIP mode.
The information you need to obtain the relevant documents and software are as
follows:
• You can refer to Motorola Web Site for the up-to-date note on installing for
Windows CE 2.0.
• Neda also keeps relatively recent notes on installing Motorola PM100C for use
with Windows CE 2.0. Visit Neda’s copy of Notes on Installing for Windows CE
2.0.
A summary of the installation procedure is included below. The text was partially
reproduced from Motorola’s Web site on May 28, 1998. Again, refer to Motorola Web
Site for the Motorola’s most up-to-date notes on installing for WindowsCE 2.0.
Establishing a New Terminal Session
1. Apply power to your handheld personal computer and verify that it is running
the Windows CE Version 2.0 operating system.
2. Unlock the PC card slot on your (HPC), insert the Personal Messenger 100C
modem, and lock the PC card slot. (Note: some HPCs do not have PC card
locks.)
3. Apply power to the Personal Messenger 100C modem.
4. If you are running the HPC on battery power, you will be asked, ”Do you want
to use this PC Card on battery power?” (Note: this will occur anytime that you
turn on your modem
5. From the HPC desktop, tap Start, Programs, Communication, and Terminal.
6. Double-tap Make a New Session.
7. Enter a session name into the Session Name field.
8. Select Motorola PM100C from the Select a Modem list.
9. Enter 1 in the telephone number field. Enter your country code and area code in
the appropriate fields.