Specifications

<P=002>
(Continued)
■ To create track numbers automatically
Before recording, press the AUTO MARK button on the remote
control.
● Track numbers are automatically created with a blank space
of at least 1.5 seconds between tracks. (Auto marker function)
If there is too much noise, track numbers may not be created.
● "A.MARK ON" will appear.
■ To record tracks as a single track
You can record several pieces of music as a single track by
disabling using the auto marker function.
Before recording, press the AUTO MARK button on the remote
control.
● "A.MARK OFF" will appear.
Note:
● If the recording level is too low, the sound becomes quieter.
If it is set too high, distortion increases.
Since CDs and DATs are digitally recorded and have a wide
dynamic range, be careful not to increase the recording level
too much.
MIC
(STEREO)
PHONES
■ Using the microphone
Press the AUX button on the remote control.
The microphone volume should be adjusted using the INPUT
LEVEL control.
● The method of recording/playing back the sound from a micro-
phone is the same as that from analogue inputs.
● When a microphone is connected, recording/playback from
other analogue inputs is not possible.
● This unit does not allow you to mix playback sound with the
sound picked up by the microphone.
● When you use a monaural microphone, recording/playback is
available only on the left channel. To record/play back on the
left and right channels, set the record mode to "MONO".
■ Headphones
● Be sure that your headphones have a 3.5 mm (1/8") diameter
plug and are between 16 ohms and 50 ohms impedance.
The recommended impedance is 32 ohms.
● When headphones are connected, the speakers are discon-
nected automatically. Adjust the VOLUME control for desired
volume.
Connect a separately available stereo microphone
and set the input to AUX.
MD-ZV30H TINSZ0217AWZZ
E-37