Service manual

MD-MX30/MX30W
– 80 –
1 CD-DRF P16 – Output CD Control
2 CD-WRQ P17 – Output CD Control
3 MD-STB P30 – Output MD Control
4 MD LOAD-SW P31 – Input For MD control (DATA when rewriting FLASH)
5 C2-CE P32 – Output VOL/TUNER Control
6 C2-SL P33 – Output VOL/TUNER Control
7 C2-SI P34 – Output VOL/TUNER Control
8 C2-SO P35 – Input VOL/TUNER Control
9 SURROUND P36 – Output "L": Surround ON (CLOCK when rewriting FLASH)
10 PROGLAM/DAT P37 – Input "H": Program rewriting mode
11 – RES – –
12 CD PU-IN AN10 – Input Pick position detection. "L" : INNER RADIUS.
13 FAN-H/L AN11 – Input High-speed when FAN-MOTOR speed detection is "L"
14 – Vss1 – Input
15 – CF1 – –
16 – CF2 – –
17 – Vdd1 – –
18 FAN-MOTOR AN0 – Output "H": FAN-MOTOR ON
19 MOTOR LOCK AN1 – Input MOTOR current detection input
20 TUNER-SM AN2 – Input TUNER signal level detection
21 DSET AN3 – Input Destination setting port
22 SP-PRTECT AN4 – Input Protection mode when 3.5 V or less
23 MULTI-JOG AN5 Stand-by Input
24 KEY-1 AN6 Stand-by Input Operation key
25 KEY-3 AN7 Stand-by Input Operation key
26 VOL-JOG AN8 – Input
27 KEY-2 AN9 Stand-by Input Operation key
28 SYS-STOP INT2 – Input Back-up mode when power failure detection is "L"
29 REMOTE INT3 Stand-by Input Remote Contorol Input
30 G1 T0 OFF Output
31 G2 T1 OFF Output
32 G3 T2 OFF Output
33 G4 T3 OFF Output
34 G5 T4 OFF Output
35 G6 T5 OFF Output
36 G7 T6 OFF Output
37 G8 T7 OFF Output
38 G9 T8 OFF Output
39 G10 T9 OFF Output
40 G11 T10 OFF Output
41 G12 T11 OFF Output
42 G13 T12 OFF Output
43 G14 T13 OFF Output
44 seg1 S14 OFF Output
45 seg2 S15 OFF Output
46 – Vdd3 – –
47 seg3 S16 OFF Output
48 seg4 S17 OFF Output
46 seg5 S18 OFF Output
50 seg6 S19 OFF Output
Pin No.
Function
Terminal Name
Setting in Reset
Port Name
In this unit, the terminal with asterisk mark (*) is (open) terminal which is not connected to the outside.
Input/Output
3.38MHz
Grid drive output 1G-14G
Segment drive
ICD01 RHiX0321AWZZ: System Microcomputer/FL Driver (iX0321AW) (1/2)