Service manual

– 17 –
MD-MX30/MX30W
Table 17 Button entry table
Display in the MD test mode 1
"Center Bar" of the level meter flashes during this mode.
Lower-case characters appear according to the 10-letter data from the MD microcomputer.
When an MD disc is already loaded: "_AUT_YOBI_" appears.
The entry to this mode becomes steady when the indication appears as the AUTO YOBI mode Figure 17-1
"_AUTO_YOBI_" indication when entering MD test mode
Figure 17-1
Button to press
Power on and off. Turns the power off when POWER ON and on
when POWER OFF.
Once[ON/STAND-BY]
Sending test mode menus. To servo adjustment mode.
(Menus concerning adjustment and EEPROM.)
Once[EQUALIZER]
Sending test mode menus. To recording mode.
(Menus concerning continuous playback and continuous recording.)
Once[X-BASS]
Sending test mode menus. To other modes.
(INNER mode menu, JUMP SELECT menu, etc.)
Once[CD-PLAY]
Sending menus backward in each mode.
(Valid in each test mode.)
Once[CD-STOP]
1) Forcibly disc unloading.
2) Adjustment value + 1.
[VOLUME UP]
1) Forcibly disc loading.
2) Adjustment value - 1.
[
VOLUME DOWN ]
1) Laser switching at "EJECT".
2) Display switching when continuous playback.
Others
Once[DISPLAY]
1) Sled motor moving outward (FWD) and continuation.
2) JUMP.
3) Address value UP.
Others
Once
Continuously
[UP]
1) Slide motor moving inward (REV) and continuation.
2) JUMP.
3) Address value DOWN.
Others
Once
Continuously
[DOWN]
Menu selection and execution.Once[MD-PLAY]
To the no auto adjustment operation mode.Once
[MEMORY/ENTER]
Normal loading.LOADING SW
Normal eject.Once[EJECT]
Stopping each test item and returning to the previous selection menu.Once[MD-STOP]
Press Function
Main unit Remote control
–
–
–