User Manual

E-27

RDS Radio

- Using the Radio Data System (RDS) -

■ To automatically play the traffic information

(EON-TI)

When the traffic information is broadcast, the radio switches to it automatically.

1 Tune in to an RDS station (when a station name is displayed).

2 Press the EON button when “EON” appears.

● “PTY TI” will flash for about 4 seconds.

● If the EON button is pressed when “EON” is not displayed, “NO EON” will

appear for 4 seconds to indicate that the unit cannot enter the EON stand-

by mode.

3 Whilst they are displayed, select the TI (Traffic Information) by

pressing the

5/35/3

5/3

2/42/4

2/4

button.

4 Within 4 seconds, press the PTY. TI button.

● “TI” and “WAITING” will appear for 2 seconds each.

● “TI” will appear, and the unit will enter the EON-TI stand-by mode.

Using the Radio Data System (RDS) (continued)

5 When a TA specified starts on an ON (other network) station, the

unit will automatically switch to that station, and “TI” will flash.

6 When the traffic information is over, the unit will automatically

return to the original station.

Checking the stand-by mode setting:

When in the EON stand-by mode, press the EON button. (“TI” → “WAITING”)

To cancel the EON stand-by mode:

When in the EON stand-by mode, press the EON button. Within 4 seconds, press it

again. (“TI” will go out.)

*07-E22-28-MD9000H(SEEG) 01.4.19, 3:08 PM27