Service manual

Revision D4-34
Troubleshooting: Elevation Motor Replacement
Series 2000 Treadmill
409110-004
Elevation Motor Replacement
Replacement
Instructions
1. Turn the power switch off, disconnect the power cord from the
wall outlet, and remove the shroud.
2. Disconnect the elevation motor power cable and remove all tie
wraps on the cable.
3. Place the treadmill on its side so the elevation motor is on top.
4. Remove the two visible mounting bolts on the elevation motor.
5. Remove the third mounting bolt behind the rubber coupling. If
the treadmill stopped at 0% elevation, you may have to remove
the wheel to reach the third mounting bolt.
6. Remove the elevation motor from its coupling and replace with
a new motor in reverse order.
7. Replace the tie wraps and activate the self-calibration feature as
instructed in chapter 3, “Maintenance.”
NOTE
The elevation motor supports the treadmill.
To prevent the treadmill from falling, only
replace the elevation motor with the treadmill
on its side.
MD1129-020C
Mounting Bolt
3 Places