Service manual

Revision D 4-31
Troubleshooting: Walking Belt and Board Replacement
Series 2000 Treadmill
409110-004
5. Slide the bracket into the frame.
6. Slide the belt off the walking board, lower end first.
7. Replace the belt in reverse order.
Walking Board
Replacement
Instructions
1. Remove the walking belt as instructed in the previous steps.
2. Remove the eight, 5/32-inch Allen-head, counter-sunk screws
on from the top of the walking board. (There are no nuts on the
underside of the board.)
3. Secure the new walking board to the bed assembly with the 8
screws.
4. Replace the walking belt and adjust the tension.
5. Activate the self-calibration feature as instructed in chapter 3,
“Maintenance.”
NOTE
The wax material on the walking board acts
as a lubricant for the belt. We recommend
that you replace the board every time you
put on a new belt to ensure the belt absorbs
the required amount of lubricant.