Service manual

Revision D4-30
Troubleshooting: Walking Belt and Board Replacement
Series 2000 Treadmill
409110-004
Walking Belt and Board Replacement
Walking Belt
Replacement
Instructions
1. Turn the power switch off, disconnect the power cord from the
wall outlet, and remove the shroud. You do not have to remove
the roller to replace the belt.
2. Remove the right end cap from the end of the treadmill and
loosen the tension bolt on the left end cap.
3. Lift up the left side of the treadmill and place the end cap that
you just removed under the left foot.
4. On the front right side of the treadmill, remove the eight, 1/2-
inch bolts that hold the frame’s sliding bracket in place.
MD1129-018B
Loosen Left Tension Bolt
Sliding Bracket Bolts
8 Places
Sliding Bracket
Slide lower end
of belt off first.
MD1129-019B