Service manual

Revision D4-20
Troubleshooting: Drive Motor Control Box Description
Series 2000 Treadmill
409110-004
FAULT
This is an open collector output that is pulled low when a fault condition
is latched.
TEMP1, TEMP2
These terminals can be connected to an external thermal switch such as
the motor over-temperature switch. The switch should be normally
closed. Opening the contact causes a fault condition.
D-connector Inputs/Outputs
D- Connector Pin # Signal Name
1 --
2 GNDISOL
3 ESTOP
4 FAULT
5 HALL2
6 +5ISOL
7 TEMP2
8 HALL5
9 START
10 STOP
11 VIN
12 HALL1
13 HALL3
14 TEMP1
15 HALL4