Service manual

Revision D 2-8
Equipment Overview : Preparation for Use
Series 2000 Treadmill
409110-004
Connector Locations
The illustration below shows the various input connectors on the rear
panel of the treadmill. Attach the appropriate controller cable from the
stress system or MTC-1 and the AC power cable.
WARNING
M15287-64A
Route the AC power
cable away from
moving parts.
MD1128-001E
220-240V~ 50-60Hz 16A
F1 0.5ASB
250V
F2 0.5ASB
250V
WARNING: FOR CONTINUED
PROTECTION AGAINST RISK OF
FIRE REPLACE ONLY WITH FUSE
OF SAME TYPE AND RATING.
RS-422
SERIAL CONT
STOP
SERVICE
treadmil
SERIES
RS-232
SERIAL CONT
CAUTION: DO NOT USE BOTH
CONNECTORS AT THE SAME TIME.
CAUTION: ELECTRICAL SHOCK HAZARD.
DO NOT REMOVE COVER. REFER
SERVICING TO QUALIFIED PERSONNEL.
RS-232 Port
(Connection to: CardioSys, MAC VU,
MAX-1, MAX Personal)
RS-422 Serial Port
(Connection to: MTC-1, CASE 15,
CENTRA)
Emergency Stop Switch Connection
Service Port
Equipotential (ground lug)
AC Power Connection
(220–240V, 50–60Hz, 20A)
ON/OFF Power Switch