Service manual

Revision D 2-7
Equipment Overview : Preparation for Use
Series 2000 Treadmill
409110-004
4. Attach the side rails to the front rail with the mated T-brackets.
Tighten the two T-bracket bolts with the Allen wrench.
Emergency Stop Switch
1. Attach the two clamp pieces to the assembled, latching
emergency stop switch.
2. Position the clamps around the treadmill front handrail and
secure with the supplied screw and nut.
3. Connect the cable from the emergency stop switch to the
mating connector on the treadmill’s rear connector panel.
4. Use the cord clips to attach the cable along the front handrail.
T-bracket
Bolts
2 Places
Nuts
2 Places
Typical two places
MD1128-005C
Align the side rails to the
predrilled guide holes in the
front rails.
MD1128-006A+
Cable
Clamp
Handrail
Emergency Stop
Switch Assembly