Service manual

Revision D 2-6
Equipment Overview : Preparation for Use
Series 2000 Treadmill
409110-004
Equipment Assembly
The Series 2000 Treadmill ships completely assembled except for the
handle set and the emergency stop switch. Attach the handle set and
emergency stop switch before applying power to the unit.
Handle Set
1. Insert the wood front handrail into the metal side rails, then
align the predrilled holes and screw in the two Phillips screws on
both sides. Assemble the optional side rails in the same way.
2. Place the assembled front handrail into the metal mounting
brackets on the front corners of the shroud. Using the supplied
Allen wrench and four bolts, secure the handrail to the brackets.
3. Place the assembled side rails into the side mounting holes and
screw in the two bolts on each side.
NOTE
As recommended by the American Heart
Association Exercise Standards (Special
Report, Vol 82, No 6), the treadmill
should have front and side rails installed
for patients to steady themselves. An
emergency stop switch must be visible
and readily accessible.
Wood Front Handrail
Metal Side Rail
Wood Side Handrail
Metal Front Rail
Screw
Screw
Right Side
Notch
Right Side
Notch
Front Handrail
Mounting Bracket
Side Rail
Mounting Hole
Left Side
Right Side
Notch
Notch Represents
Right Side
Notch
1
2
3
MD1128-004B
MD1128-003C